-
[[[[[cancelled account]]]]]
why my account has been cancelled with no advise or no reason please I want to get back my service that I use daily. thanks
-
Native Access Install Failures even after following instructions per below repeatedly
https://support.native-instruments.com/hc/en-us/articles/360016913977-Native-Access-Error-Message-Installation-Failed-Mac Native Access two products Previews Update and Session Guitarist- Strummed Acoustic Update installation failed even with Full Disk Access enabled for Native Access and NTKDaemon and multiple restarts.…
-
NA update
I've still got NA 3.10.3. I have not opened it for quite a while, actually since I downloaded everything for Komplete EC 14 in the summer which went without any problems. If I open it now to which version will NA then be updated? And is it safe to do so, with the stories of bugs I have heard I am reluctant. I don't really…
-
Unable to Register Komplete Kontrol A25
I've been stuck trying to register my new keyboard. I've tried reinstalling Native Access, but each time I submit the serial (serial covered for obvious reasons), I get the following error: I'm on an intel Mac, and I've allowed Native Access to run in the background, but I'm out of ideas. I wasn't able to see anything in…
-
Native Access 1 and NA2
I have just installed Komplete 15 standard using Native Access 1 and most software installed cleanly. I did have a problem installing Izotope Ozone 11. You have remedied that problem by suggesting I use NA version 2 (Doh!). That fixed the problem by I see that I have 83 updates to the software I installed yesterday. Do…
-
M3pro Macbook: NI Access from M1/M2-installer - being prompted to reinstall...?
Hello y'all, as stated above, I installed Access 2 - as I am on an arm-laptop, I chose M1/M2 as installation package. All went smoothly -at first, that is: download of installer without problems. installation of excess 2 without problems. a pop-up informed that A2 would be installed as soon as I would shut down A1… Thus, I…
-
Confusion: NI-Acc.1 installed, prompt to upgrade to NI-Acc2... ?!
1st off: Hello World, hello fellow music enthusiasts! I just got my new Macbook (MBP, M3pro, 18GB RAM) & migrated my warez from my old Intel i5-MBP. Native Access & TRAKTOR didn't cause problems… or so, I thought: When starting up N-Acc (V.1) for the first time, I got a message to upgrade to V.2, since V.1 would not…
-
Installation Failed error message on Native Access 2, but full disk access has been granted
Hello, Pulling my hair out over this one. Have downloaded Native Access 2 and tried to instal Kontakt 8 and Cycles but whenever it gets to the 'finalising' stage, the installation fails (see screen shot). I have gone through the trouble shooting stages linked in the error message and granted NA and Daemon full disk access…
-
NTKDaemonService
Hello everyone, while installing Native Access, I get this error message: "Service 'NTKDaemonService'(NTKDaemonService) failed to start. Verify that you have sufficient privileges to start system services" I tried several things and still the same message. I would be happy for help.
-
Kontakt 8 purchase does not let the new libraries install correctly
the first two in native access want to install to some path like C:\users\public\publicdocuments\native instruments but my defined content path is on another drive and It will not accept that other path I understand that programs and content may need to be on different paths but these point to the content path defined in…
-
Double purchase of Instrument
This summer I have the S88 MK3 and Komplete 15 Ultimate. All works fine and the sounds are great. But I have made a mistake. Last week I ordered the instrument Skanner XT (€50). Now I see that Skanner XT was allready included in Komplete 15 Ultimate. So I payed Skanner XT twice. Oeps stupid and I was wrong. Can Native…
-
Uninstall in Native access?
This discussion was created from comments split from: Ask Kontakt 8 creators anything.
-
Maschine MK1 Lost Serial
I purchased a Maschine MK1 around ten years ago and barely used it. I want to use it again now. Unfortunately I have lost the serial number and access to the email account I registered it with. I have the CD but no disc drive. Is there a way I can get a new serial number and register it to my Native Instruments account?
-
native access failed download of Komplete Kontrol update
I have tried many times and Native Access continues to fail downloading and installing Komplete Kontrol update.
-
Native Access 2 can't connect to internet after installation
I just ran the Native Access 2 installer and was greeted with this message: Clicking the Retry button does nothing. I'm stuck here. Has anyone else had this issue, and is there a known solution?
-
NTK Daemon will not install
I’m having trouble installing native access due to NTD Daemon failing to install and run, when it try’s to start services , it says I do not having the sufficient privileges, I have tried the 5 suggested solutions and nothing has worked. Any help would be appreciated. I was upgrading from 13 to 15. Interestingly it worked…
-
problem installing product
Dialog box say 'In order to sucessfully finish installation, please locate xxx library folder on your system. What is a library folder? What distinguishes it from any other folder. When I select 'Native Instruments' it says 'That path is invalid, please 'read how to fix this'. That link makes a selection 'light version',…
-
No you can't use your worst programmers for the installer
No one buys the installer, it's not something you can market as an advantage, it's more or less a nuisance project you just have as enabling background technology, it's something you can break junior engineers on before they introduce crashes into the sessions of high-profile clients on deadline… Nope. All of the above is…
-
can't login to Izotope Product Portal after updating to Mac OS 15.0
I have tried to reinstall the softwareware - but no luck ?
-
Traktor 3 Pro for Mac M1 Ventura + for Intel Big Sur: How to install to Big Sur OS 11.7.10
Help! Bought Traktor Pro 3 for my (M1) MacBook Pro. As I prefer to use the book for Live, I would like to transfer Traktor Scratch Pro 3 to my older book (Intel) identically. As written by Native, the 3.4.1 Traktor Installer does not work on Ben Sur Intel (Traktor 3.4.1 Installer needs to be updated says Mac) Native Access…