-
Can the Maschine Mikro Mk3 be used as an Abelton Midi controller?
Question as above really, I believed it could be and recently purchased one. However After following the NI instructions for installing the script for Maschine Mk3 for Ableton 11 on the Mac, no such joy. I do not even get power going to it unless I launch the VST.
-
Maschine 2.15.2 R2 freezes when browsing Kits
Hello dear community, I am a relative newbie and have a problem that is getting on my last nerve and causing me to panic. :-) Briefly about the setup: MBP M1 Max, machine MK3, machine 2.15.2 (R2). Machine MK3 via USB hub to Mac, hard drive directly to Mac. Hard disk is recognized properly, here I had suspected the error in…
-
Where is AUDIO 4 Control Panel ?
Hello everybody, I need your help. I connected the Audio 4 to the Mac because I would like to use it to record (no Traktor) a dj set with Ableton/Audacity from the pioneer DJM-400 mixer. The problem is that the audio signal from the mixer arrives distorted because it's too loud and I don't understand where I can lower the…
-
Maschine 2 CPU overload in standalone but not in Logic Pro?
Have been using Maschine standalone since I got my Macbook Pro 2015. Every time when I add some plugins in the Master section like Ozone etc.., the CPU gets overloaded after some time during playback. Today I just loaded Maschine in Logic and to my big surprise, the CPU wasn't overloaded at all with the same project. How…
-
Tips: Can not install NA2 by dragging and dropping (Mac)
If this happens, then you probably downloaded the wrong installer, you need to check if your Mac has an Intel processor or an M1: Does My Mac Have an M1 or Intel Processor? For all Mac computers equipped with a Silicon/M1 processor, please use the ARM installer. For all Mac computers equipped with an Intel processor,…
-
Is Traktor Pro 3 v. 3.2.0 compatible with Mac OS Monterey?
I haven't upgraded to Monterey, because I was waiting for confirmation of compatibility with Traktor. Now I believe the latest version of Traktor IS compatible with Monterey. My question is: can I upgrade to Monterey and still use Traktor 3.2.0? And if not, how much, if anything, does the upgrade from Traktor 3.2.0 to…
-
why am i getting spikes/noises from my Macbook to my S4 Mk3?
i keep getting very loud pops through my Kontrol S4 Mk3. i unplug everything from it (decks and mic) except the lead from my macbook pro and it still pops and makes the tracks dip out, so i figure it must be the laptop/cable. it is driving me to complete craziness. never used to do it. the Load is showing minimal. it is…
-
Can't get out of clip/song mode and samples playing over each other.
I'm not sure if I accidentally pressed something or what happened, but suddenly my controller and software has changed to Song Mode and its not letting me return to Idea Mode to work with patterns instead of clips. The most frustrating part about this is in Song Mode, my samples are playing over each other when it goes to…
-
Can't map my dicer to the software
Recently updated to Traktor Pro 3 on Mac but I cannot map my dicer to the software. Any advice?
-
BigSur support for X1 Z1 hardware on MBA 11"
Hi guys, I run the latest Traktor s/w on my 11" MBA 2015 with an X1 mk2, and a Z1 connected. Will I have a stable set-up if I upgrade from Mojave to BugSur? Regards, S
-
How can you zoom into a waveform in Traktor LE 2?
Very out of date I know, but I re-discovered my old decks and wanted to have a play. I've been trying to set some beat grids up but for some reason I can't zoom in/out of my waveform using the below buttons. Just want to know if I'm going crazy or not as I can't find any info about why this could be happening - most other…
-
Where do I find my missing samples??
I transferred music over to my new computer windows to Mac and for some reason some songs I previously recorded will not so samples and I go to samples in Maschine folder and I cannot load them in but in one song all the samples where there.... Where do I find my missing samples??
-
Wheel of death and no more sound by using Pioneer Mixers as Interface with DVS
As the title already says, I have sometimes complete drop outs at irregular intervals after a longer playing time. The sound stops and Traktor no longer reacts. It can then only be terminated immediately via the Task Manager. The problem only occurs when I play longer, i.e. more than 3 hours. Unfortunately, the problem…
-
Maschine Integration and workflow
Hello everyone this is my first post here as am new to maschine I got a little around it but I have few questions My only use to maschine is for drum sequencing live nothing else The main point in my setup is Xone96 & Xone k2's ( 2 ) Questions: 1- Tried to map macros and levels of groups to my k2 faders. it is taking the…
-
Maschine saving my samples in the one shots directory under each different vendors.
Good day! There's a new saving behavior i've noticed. After i upgraded my macOS from Catalina to Monterey everytime i save project with samples, the samples appear in the one shots directory under each vendors they belong too. It's a gray maschine 2 icon with no thumbnail. Any idea why is this happening and how do i fix…