Maschine+ Power Bank guide
Comments
-
Ah nice thread.
I needed something similar for my Traktor S4 mk3, but from a ~12v source battery. I ended up with a step up / step down converter and some soldering.
For the laptop I bought a 12v car battery to USB C converter. If I had known those 15V PD Cable existed I would have gone that route for the Traktor controller as well.
3 -
Thanks, Carlos.
PD and USB-C are finally becoming common thanks to modern phones and laptops with low power consumption.
What's that setup for? Outdoor events?
0 -
Yeah, that was the idea. Though I have not used it much for that. One time I was in the middle of Copenhagen + a large soundboks. Fun times.
But also to keep all my gear in one place. It has audio out and power in on the backside, for easy connection without having to lift the s4.
1 -
A little off topic, but I use the Apple MacBook Air M1 power supply with the mentioned 15V PD Cable, also cool because I can leave the original one in the living room.
3 -
Ohh... Snap, never thought of that, it works.. It's nice to know, thanks for sharing! I guess it can be an alternative for anyone who wants an extra power brick.
For giggles I tried the cable plugged directly into the M1 Macbook Air lol, M+ doesn't boot I guess it can't give enough juice but would be funny/ironic to power a standalone with a laptop.
0 -
Just having this cable has a backup might be a good idea. When you go on a gig but forget your power supply. It's easer to find some USB-C ones and plug your cable in, instead of trying to find a 15v barrel one :D
1 -
Good tip. I've had that happen and had to turn to controller mode instead. I got two cables so one is going permanently into my bag!
0 -
Seems to be running without issues.
Cheap powerbank from Amazon and cable from AliExpress. Although it doesn't meet the specs at all the Maschine is running perfectly fine on it. Ideal when traveling :)
1 -
MERRY X-MAS @ all!
This is my solution:
So far it works perfectly! In the next days/weeks I´ll provide some information regarding hours of battery usage.
a) EASYLONGER 26800 mAh USB-C Powerbank with up to 100W PD. This thing is able to charge my 16" Macbook.
https://www.amazon.de/dp/B09FT4SHSV?ref_=cm_sw_r_ud_dp_A56M9GTHKPPNJJ47CBQY&th=1
b) DSD TECH - power chord (15V 3A)
https://www.amazon.de/dp/B09FT4SHSV?ref_=cm_sw_r_ud_dp_A56M9GTHKPPNJJ47CBQY&th=1
Remark: Currently, this hyperlink is not showing the 15V cable, because obviously, it is out of stock.
4 -
So far, battery loading with the 96W power adapter from my 16" MacBook takes approximately 1:30 hrs. 👌🏻
BTW: Is there no possibility to edit my previous post in this "new" forum? 🤷♂️
1 -
You can edit your post for a couple hours after sharing it. Any mistake you'd like to change?
1 -
Hey Nico, thanks for this advice.
I´m fine. No need to change something.
I was just missing an "edit button". Since I was not really active in this new forum, I need some more time to get familiar with all new things in here. 😉✌🏻
0 -
15V Ripcord runs smoothly even if the Maschine + has 100% CPU.
The maximum power I mesured that Macshine + is draining was 10.12W .
P=U*I so I =P/U =10,12W/15V= 0,67 A or at 5V (from Battery Pack)-> 10,12W/5V= 2,024A
0 -
The Ripcord is rated at 0.6A thus it’s actually throttling your M+.
Try with a sufficient power source (Power bank with DC 15V/3A) and you will get higher current read outs.
0 -
Not sure if it's throttling as that's hard to verify but the power requirements have to be above what's necessary just to allow users to connect devices to the M+ that take power from it, like External HD's, MIDI Controllers, or anything you might plug in it's USB ports in the future. So, the offitial minimum required specs have a fair bit of headroom.
I'm not an expert but 0.6A VS 2.66A sounds like a massive difference. USB-2 is 500 mA, M+ has 2x so that's 1A, subtracting that from the official 2.66A and we get 1.66A, so... I personally wouldn't use any power source with an amperage lower than that - assuming I'd never use anything connected to the USB Ports.
Underpowering such an expensive device long term to save 50$ or so on a propper PD solution seems all kinds of wrong IMO, but again... I'm no electrical expert.
0
Categories
- All Categories
- 18 Welcome
- 1.6K Hangout
- 66 NI News
- 858 Tech Talks
- 4.4K Native Access
- 17.5K Komplete
- 2.1K Komplete General
- 4.6K Komplete Kontrol
- 6.1K Kontakt
- 1.6K Reaktor
- 397 Battery 4
- 887 Guitar Rig & FX
- 450 Massive X & Synths
- 1.4K Other Software & Hardware
- 6.1K Maschine
- 7.8K Traktor
- 7.8K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators