Busy season in progress... Please note that due to a high volume of requests, the response time from our support is currently longer than usual. Chat is temporarily not available. We thank you for your understanding.

The Ultimate Magic Way to get your Reaktor Stuff running on Native Instruments Maschine+

kinskop
kinskop Member Posts: 16 Sine

Hey there...

...since there is a lot of confusion if it's possible to load Reaktor User Ensembles into the Maschine+, I thought I'd invest some time and write a propper Tutorial about it. Because it is possible and it works very well. I sure hope you find it useful. It's a bit more reading content then I expected but if you are already a tiny bit into the topic, I guess you can skip the whole intro part...

I would like to use this thread for further discussion and questions. And hopefully I'm not the only one ready to give some answers. Help each other out 👨‍🎓

Cheers!

Eric

Comments

  • kuenala
    kuenala Member Posts: 4 Sine

    Wow, thank you for this extensive post and the documentation. Will give it a go!

  • tetsuneko
    tetsuneko Member Posts: 196 Saw
    edited November 1

    My only point of criticism is that you do not mention that Maschine only allows the first 99 Reaktor IDs to be controlled/mapped in Maschine/M+. This is why "Compress&Sort ID's" is a good idea. However, even that will not help if you have over 100 parameters.. This can be problematic when importing complex existing ensembles.

    Your method differs slightly from the way I personally do it, but if it works, its all good!

Back To Top