How to change OSC messages from Float to Integer?

FJ Roberts
FJ Roberts Member Posts: 2 Newcomer
in Reaktor

I was trying for a while to control a few apps and mixers using OSC templates using Reaktor, and I always found myself unable to control certain parameters. After using an OSC monitor I found out that Reaktor always outputs FLOAT OSC messages and certain parameters need them to be INTEGER values or even just STRINGS.


After trying out Touch OSC I found it so easy to set it up there and everything works flawlessly, but I don't seem to find a way to switch from FLOAT to INTEGER in Reaktor. Is it not posible?

Tagged:

Best Answer

  • bolabo
    bolabo Member Posts: 97 Advisor
    edited December 2022 Answer ✓

    Unfortunately Reaktor can only send values as floats over OSC.

    In the past I have used a Pure Data patch to convert float values, in OSC messages from Reaktor, into strings before sending them on to the Atom text editor to execute Tidal Cycles commands, a bit of a faff but it worked.

Answers

Back To Top

Categories