Issue with saving External Hardware instruments
Options
I have a bunch of external hardware that I like to control via Maschine, however the issue I have is that when I save any new instrument I have created as a “Sound” (which is essentially just the midi channel settings) when I re-load that into a new project, the midi channel settings are always reset to Channel 1, and I need to go into Macro settings and set them again.
Is this intended behaviour, or am I doing something wrong?
Tagged:
0
Comments
-
Hello,
maschine uses the pad number as midi ch setting, so if you load the same preseton pad 3 it will set midi ch 3. So maybe if you often use combinations of synths you save the preset as group preset where you have 4 synths or whatever set up.
0
Back To Top
Categories
- All Categories
- 18 Welcome
- 949 Hangout
- 56 NI News
- 471 Tech Talks
- 2.5K Native Access
- 11.1K Komplete
- 1.3K Komplete General
- 3K Komplete Kontrol
- 3.9K Kontakt
- 842 Reaktor
- 298 Battery 4
- 611 Guitar Rig & FX
- 325 Massive X & Synths
- 761 Other Software & Hardware
- 4.1K Maschine
- 4.8K Traktor
- 4.8K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators