Undo/Redo problem in Maschine
I have updated to the last Komplete 14 and Ozone is not loaded correctly.
But the worst is my UNDO/REDO/STEP UNDO/STEP REDO not work. In Undo it say something totally different than I just added.
I tried to remove my start project and also reinstall whole Maschine. Nothing helps.
Can I remove whole Maschine with all register setup and then try to install it again ?
Have anyone else the same problem ?
Just now i can't use my maschine :(
/Jörgen
Best Answer
-
We didn’t hear back from you. We’re closing this thread. If you still need assistance on that matter, please get in touch here: http://bit.ly/NIsupport_maschine
0
Answers
-
Hey @MrBase Could you give more context? Undo/Step will remove the step you just put in. Do you mean that when you hit Redo Step it brings a step you didn't put in? Can you give a concrete example, maybe with a picture or screenshot?
0 -
We didn’t hear back from you. We’re closing this thread. If you still need assistance on that matter, please get in touch here: http://bit.ly/NIsupport_maschine
0
Categories
- All Categories
- 18 Welcome
- 949 Hangout
- 56 NI News
- 471 Tech Talks
- 2.5K Native Access
- 11.1K Komplete
- 1.3K Komplete General
- 3K Komplete Kontrol
- 3.9K Kontakt
- 842 Reaktor
- 298 Battery 4
- 611 Guitar Rig & FX
- 325 Massive X & Synths
- 761 Other Software & Hardware
- 4.1K Maschine
- 4.8K Traktor
- 4.8K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators