The automation module.

peppe from sweden

I know there are blocks with automation recording but still I want to be able to build my own automation and fully understand it.

First input is "Touch-state" and I don't understand it. The others I understand. If I would control it with a knob or ramp etc I send it to the value input.

Also there is no explanation what the sel (selector?) input takes/is.

And going further and wanting to record and store the values, a event table is the base module right?

Thanks.

PS. I'm in the mountains and didn't bring my laptop so can't hoover over modules to get info on inputs/outputs. It's raining and i read the building with primary modules all day's long 😄

colB

Go forward two pages to page 175 and you will find details about the sel input

colB

Go forward two pages to page 175 and you will find details about the sel input

peppe from sweden

I did thanks!