The automation module.
I know there are blocks with automation recording but still I want to be able to build my own automation and fully understand it.
First input is "Touch-state" and I don't understand it. The others I understand. If I would control it with a knob or ramp etc I send it to the value input.
Also there is no explanation what the sel (selector?) input takes/is.
And going further and wanting to record and store the values, a event table is the base module right?
Thanks.
PS. I'm in the mountains and didn't bring my laptop so can't hoover over modules to get info on inputs/outputs. It's raining and i read the building with primary modules all day's long π
Best Answer
-
Go forward two pages to page 175 and you will find details about the sel input
2
Answers
-
Go forward two pages to page 175 and you will find details about the sel input
2 -
I did thanks!
0
Categories
- All Categories
- 22 Welcome
- 2.2K Hangout
- 86 NI News
- 1.5K Tech Talks
- 2.6K Native Access
- 14.2K Komplete
- 1.4K Komplete General
- 3.1K Komplete Kontrol
- 4.1K Kontakt
- 3.6K Reaktor
- 342 Battery 4
- 639 Guitar Rig & FX
- 329 Massive X & Synths
- 794 Other Software & Hardware
- 4.2K Maschine
- 5.3K Traktor
- 5K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators