Timecode signal routing problems in traktor 4.1.0

I came across a strange fact in the update to 4.1.0.

If you send a timecode signal to both adjacent channels A-C or B-D, only channels C and D work and can be controlled. If you send only to A and B, then they connect and are controlled by a timecode.

Although on 4.0.2 the control works on both channels with absolutely the same settings, then I choose from the mixer which one I specifically want to control at the moment.

Does anyone know, if this functionality was specifically removed, or is it a BUG???

4.0.2

4.1.0

Find more posts tagged with

Bug

Traktor Pro 4

Accepted answers

Martiniix_NI

Heyo!

We are looking into this issue and hopefully we will get back to you soon.

All comments

Owner

Hey, there is already a thread here in the forum that describes the same problem:

https://community.native-instruments.com/discussion/38078/traktor-input-routing-issue-for-single-timecode

I hope that it is just a bug that arose while solving another problem and can be solved in the next hot fix!

I suspect that this problem was introduced to make interfaces with more than 12 channels compatible with Traktor again. See here in the release notes of TP4.1:

https://support.native-instruments.com/hc/de/articles/360017233958-What-s-New-in-Traktor-Pro-4-1

Support for audio interfaces with 12+ channels
Traktor now fully supports audio interfaces with more than 12 channels.

@Allan_NI please have a look into this one.

Deejay Gucci

your deck b and d are on the same channel... already it's not good...

Pavel DarkLights

https://community.native-instruments.com/discussion/comment/190487#Comment_190487

I use two timecodes to control 4 channels in the tractor, and switch them between internal i relative modes on the mixer (Z2)

Everything worked fine until the last update 😩

Pavel DarkLights

thanks a lot 🙏

Martiniix_NI

Heyo!

We are looking into this issue and hopefully we will get back to you soon.

Quick links

Unanswered questions