Stems are getting out of time when using the transport track strip

Hi I am newly using a Traktor s8, And I was under the impression from past use that if I hold down shift and run my finger to the desired point on the jog strip that when I let go it will play there. Instead what I am experiencing when using stems(4 tracks), I jog forward with shift and then it takes to where I fast forward but some of the stems are out of time with each other. If I fast forward to a point like this on my laptop in the traktor pro 3 software it jump there fine but when doing it on The controller, the stems get out of time from each other. I figure there must be a special setting or something I need to push in the preferences to fix this but unsure of which one -have any of you experienced this with a traktor controller and stems? Appreciate any shared knowledge.
Answers
-
Hey @Ncyancy
Are you using the Traktor factory stems? If not, it would be great to check if the same happens with the factory ones.
I would also make sure to be using the latest Traktor 3.5.2 update available in Native Access, as well as the latest software for the S8 you can find here:
https://www.native-instruments.com/en/support/downloads/drivers-other-files/
0
Categories
- 4.8K All Categories
- 17 Welcome
- 228 Hangout
- 35 NI News
- 102 Tech Talks
- 421 Native Access
- 2.2K Komplete
- 243 Komplete General
- 477 Komplete Kontrol
- 852 Kontakt
- 241 Reaktor
- 73 Battery 4
- 141 Guitar Rig & FX
- 106 Massive X & Synths
- 84 Other Software & Hardware
- 1.2K Maschine
- 11 Sampling Room
- 1K Traktor
- 858 Traktor Software & Hardware