tune problem

CK_S
Member Posts: 5 Newcomer
Hello i have a strange problem when try to create some custom slider knob controls to adjust group tune.
i have done this in the past via menus and arrays for fixed octave, interval values and detune in the same time and the code worked flawlessly.
this time i m trying to to the same with a custom slider with 25 frames and typed values of -12, 0 +12. but this time the code doeas not do anything even if i type a fixed value like 500000 inside the command.can anyone help or correct me?
old code: set_engine_par ($ENGINE_PAR_TUNE,$slidertunedco2+%P2_OCT_TYP[$OCT_SEL_P2]+%P2_INT_TYP[$INT_SEL_P2],$CUR_GROUP,0,-1) current code: on ui_control ($slidertrans1) $CUR_GROUP :=1 while( $CUR_GROUP<=50) set_engine_par ($ENGINE_PAR_TUNE,333332 + ($slidertrans1 * 13889),$CUR_GROUP,0,-1) inc( $CUR_GROUP) end while end on
Tagged:
0
Comments
-
you don't need the while in there.
0
Back To Top
Categories
- All Categories
- 21 Welcome
- 753 Hangout
- 73 NI News
- 356 Tech Talks
- 1.6K Native Access
- 7.2K Komplete
- 938 Komplete General
- 1.7K Komplete Kontrol
- 2.7K Kontakt
- 660 Reaktor
- 229 Battery 4
- 399 Guitar Rig & FX
- 264 Massive X & Synths
- 392 Other Software & Hardware
- 3.1K Maschine
- 23 Sampling Room
- 3.8K Traktor
- 3.5K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators