reactor core

11nikita11 · May 11

Hi, how to make sample hold in reactor core? I need an oscillator with pitch and frequency inputs. How to make it? Oscillators in core have only frequency input so I need pitch input too for oscillator modulation

PoorFellow · May 11

https://community.native-instruments.com/discussion/45103/reactor-core

I know only little about Reaktor , but I think that some info for Reaktor 6 is only found in Reaktor 5 documentation.

In this case could you possibly be looking for info about Using Audio as Control Signal ?

Ref. : Page 61 : 2.5 Using Audio as Control Signal

PoorFellow · 10:51AM

P.S.

I did a little more looking into your question today , and in extension of my answer yesterday then try looking at page 39 in same manual REAKTOR 5 Core Reference English (REAKTOR 5.5 Core Reference) ,

at page bottom you will see that it says "Right-click in the background of the normal area and select Standard Macro > Convert > P2F" ,

as well as it is referred to on page 215 and 216 :

17.35
H.35. Convert > dP2FF
Converts a control signal from an interval in pitch scale (pitch difference in semitones) to a frequency ratio.
▪
12 semitones  2
▪
-12 semitones  -2
▪
etc

17.39
H.39. Convert > P2F
Converts a control signal from pitch scale to frequency scale.
E.g. pitch 69 translates to 440 Hz.

gentleclockdivider · 11:53AM

Here you go

11nikita11 · 5:22PM

Please explain how it works?

reactor core

Comments

Categories