Duplicate track to other Deck => Clone STEMS settings

macsoft · April 12

I use duplicate track to other deck a lot. The problem is the STEMS settings don't duplicate.

So If if I mute the voice on a STEMs track, and then duplicate it to other deck, the voice will pop up. this is a pain.. I have to remember to manually duplicate the STEMS settings before duplicating it, witch slows down a fast performance switch.

Any plans from Native on getting this fixed?

Owner · April 12

+1

It also annoys me that I can't reset the deck controls when I load a new stem track into the same deck. It would be helpful if this could be taken into account in the deck settings.

Sure, we could probably get around this with your own mapping, but I find that really tedious, since the desired function already exists in the Traktor settings, but in my opinion it doesn't work properly with the stem decks, or would have to be expanded accordingly.

Stevan · April 13

I can make mapping that duplicate all controls you need, mute-fx-volume-filters etc. Send me a message if you are interested or really need it - won't be cheap though.

macsoft · April 13

https://community.native-instruments.com/discussion/comment/221428#Comment_221428

thanks, my controllers are pretty much topped out on mapping. problem is you only have 8 modifiers, and I've used them all.

Stevan · April 13

It sounds like you are using one of default mappings where only 8 modifiers is a limit. For some reason, we are stuck at 8 modifiers for decades. My mapping is it's own component to the existing mappings and will listen to "deck load" input. This means you get all parameters duplicated even if you load with a mouse and keyboard.

macsoft · 12:52AM

https://community.native-instruments.com/discussion/comment/221570#Comment_221570

nope, i've built my own mapping from scratch. But i've used up all the modifiers in other tricks I do.

macsoft · 12:53AM

https://community.native-instruments.com/discussion/comment/221383#Comment_221383

it makes sense to have that option too.

Stevan · 5:50AM

https://community.native-instruments.com/discussion/comment/221792#Comment_221792

Well if you don't use a default mapping (for Traktor controller) then just add another mapping device and port it to your controller. It will give you another set of 8 modifiers.

Duplicate track to other Deck => Clone STEMS settings

Comments

Categories