Duplicate track to other Deck => Clone STEMS settings

macsoft
macsoft Member Posts: 140 Helper
in Traktor Software & Hardware

I use duplicate track to other deck a lot. The problem is the STEMS settings don't duplicate.

So If if I mute the voice on a STEMs track, and then duplicate it to other deck, the voice will pop up. this is a pain.. I have to remember to manually duplicate the STEMS settings before duplicating it, witch slows down a fast performance switch.

Any plans from Native on getting this fixed?

Comments

  • Owner
    Owner Member Posts: 612 Guru

    +1

    It also annoys me that I can't reset the deck controls when I load a new stem track into the same deck. It would be helpful if this could be taken into account in the deck settings.

    Sure, we could probably get around this with your own mapping, but I find that really tedious, since the desired function already exists in the Traktor settings, but in my opinion it doesn't work properly with the stem decks, or would have to be expanded accordingly.

  • Stevan
    Stevan Traktor Mapping Mod Posts: 2,257 mod

    I can make mapping that duplicate all controls you need, mute-fx-volume-filters etc. Send me a message if you are interested or really need it - won't be cheap though.

  • macsoft
    macsoft Member Posts: 140 Helper
    https://community.native-instruments.com/discussion/comment/221428#Comment_221428

    thanks, my controllers are pretty much topped out on mapping. problem is you only have 8 modifiers, and I've used them all.

  • Stevan
    Stevan Traktor Mapping Mod Posts: 2,257 mod

    It sounds like you are using one of default mappings where only 8 modifiers is a limit. For some reason, we are stuck at 8 modifiers for decades. My mapping is it's own component to the existing mappings and will listen to "deck load" input. This means you get all parameters duplicated even if you load with a mouse and keyboard.

Back To Top

Categories