Stem separation using Traktor 4 Pro ?

Botewind
Botewind Member Posts: 7 Newcomer
edited March 13 in Traktor Software & Hardware

im using traktor 4 pro for the stem separation.

I did it. Appears the stem logo in the track, but when i put on the deck does not appear separated.

See below the photo.

IMG_9877.jpeg


and another question. Whats the best mac for this, i7 or m1?

Thank you

Best Answer

  • lord-carlos
    lord-carlos Member Posts: 4,040 Expert
    Answer ✓

    If you are using a modern Traktor controller, try double pressing the load button. If you are only using mouse/keyboard, try holding .. shift? while dragging the file into the deck.

    You can turn the behavior around in the settings. Then it will automatically load a stem as a steam unless you double press / hold shift.

    I would today not buy a intel mac any more. Hold back on the m4 though, I have seen some reports of controllers not working. m1, m2, m3 should be gucci as far as I can tell. I'm a Windows user though.

Answers

  • lord-carlos
    lord-carlos Member Posts: 4,040 Expert
    Answer ✓

    If you are using a modern Traktor controller, try double pressing the load button. If you are only using mouse/keyboard, try holding .. shift? while dragging the file into the deck.

    You can turn the behavior around in the settings. Then it will automatically load a stem as a steam unless you double press / hold shift.

    I would today not buy a intel mac any more. Hold back on the m4 though, I have seen some reports of controllers not working. m1, m2, m3 should be gucci as far as I can tell. I'm a Windows user though.

  • Botewind
    Botewind Member Posts: 7 Newcomer

    the problem was in the visualization of the decks. Some of them dont appear the separation of the stems

  • lord-carlos
    lord-carlos Member Posts: 4,040 Expert

    Did you solve your problem?

  • Botewind
    Botewind Member Posts: 7 Newcomer

    yes. Thank you

Back To Top

Categories