im using traktor 4 pro for the stem separation.
I did it. Appears the stem logo in the track, but when i put on the deck does not appear separated.
See below the photo.
and another question. Whats the best mac for this, i7 or m1?
Thank you
If you are using a modern Traktor controller, try double pressing the load button. If you are only using mouse/keyboard, try holding .. shift? while dragging the file into the deck.
You can turn the behavior around in the settings. Then it will automatically load a stem as a steam unless you double press / hold shift.
I would today not buy a intel mac any more. Hold back on the m4 though, I have seen some reports of controllers not working. m1, m2, m3 should be gucci as far as I can tell. I'm a Windows user though.
the problem was in the visualization of the decks. Some of them dont appear the separation of the stems
Did you solve your problem?
yes. Thank you