Maschine 3.0 missing all sounds?

2»

Comments

  • ALDREAD
    ALDREAD Member Posts: 280 Pro
    edited November 2024
    https://community.native-instruments.com/discussion/comment/189431#Comment_189431

    This user had issues , so updated to somona , they also checked Mac privacy settings, and made sure maschine 3 had full disk access

    https://community.native-instruments.com/discussion/38192/maschine-3-0-missing-my-expansions-and-kits-errors-opening-2-0-projects#latest

  • ozon
    ozon Member Posts: 1,911 Expert

    Allow Maschine 3 full disk access in the macOS security settings.

  • Skelf
    Skelf Member Posts: 6 Newcomer

    Tried that as well. I'm going to update to Sonoma

  • Skelf
    Skelf Member Posts: 6 Newcomer

    Well done everything suggested everything I can find. Updated to Sonoma still the same issue. I give up until NI can suggest a fix for this.

  • ALDREAD
    ALDREAD Member Posts: 280 Pro
    https://community.native-instruments.com/discussion/comment/189817#Comment_189817

    one last thing that you could try , I read this in another thread , goto settings / libraries/ user and add the path there and rescan

    you could also try reinstalling the libraries

  • ALDREAD
    ALDREAD Member Posts: 280 Pro
    https://community.native-instruments.com/discussion/comment/189817#Comment_189817

    https://community.native-instruments.com/discussion/38301/maschine-2-factory-library-not-see-in-the-maschine-3#latest

  • Skelf
    Skelf Member Posts: 6 Newcomer

    Sounds have all reappeared. Unfortunately I have no specific answer as to why. Been tweaking stuff every where in relation to NI and nothing appeared to make any difference. So I gave up and went back to Maschine 2. Launched 3 for one finally fingers crossed time and everything was there. If I work out why this happened I will post here.

  • jmhorvat
    jmhorvat Member Posts: 9 Newcomer
    edited November 2024

    Ok so i did the rescan however I didn't select the whole list smh

    I just needed to highlight everything hit rescan and it up and running

    why you have to highlight everything is beyond me if its in the folder should rescan

  • jossick
    jossick Member Posts: 1 Newcomer

    I successfully fixed this problem :) I had the same issue, Maschine 2.0 worked fine but 3.0 was only displaying a tiny fraction of my sounds/instruments etc. Rescanned a few times, upgraded MacOS, uninstalled/reinstalled Maschine 3.0… Still nothing.

    So I went to NI Support and their bot sent me here: https://support.native-instruments.com/hc/en-us/articles/210277145-My-Maschine-Browser-is-empty-or-incomplete

    Followed the steps and it worked immediately!! I subsequently had to rescan my User Library to get that to show as well.

Back To Top

Categories