Router Issue
Does anyone know why this doesnt work?
I am trying to make a simple macro to control the decay of a HiHat. The upper part works fine If the pitch is either 66 or 70 the gate goes out trough the G output. But the lower part does not work. It is supposed to select the decay time provided by the Op and Cl inputs, if the incomming pitch is 66 the Cl decay should go trough and if it is 70 the Op decay should go through. But it doesnt, I get the same decay time whatever pitch comes in.
Comments
-
If you want more people to take a look at something Reaktor layout then it is always a good idea to attach the Reaktor .ens save file both to save other people time but also to make sure that people are looking at exactly the same as you do layout wise !
1 -
What is attached to the op and cl inputs?
0 -
OK, that's the problem.
Router only route events. KNobs only generate events at initialisation, or when you turn them. So with the knobs just set at a constant value, different note values will change the route, but there are no events being routed, so nothing actually happens.
What you need is a latch for each knob value that is driven by the note event, that way every time a new note arrives, it also generates an even for each knob, which will be sent through the router. Look up latches in the core manual to see how they work. Best read up on the core even model too ;)
0 -
Thanks
That solved the problem, I thought the values from the knobs would be readable all the time without having to store them into latches.
0 -
Knobs can't be read , they send .
If they would send all the time that would be an immense and needless cpu overhead
0
Categories
- All Categories
- 19 Welcome
- 1.4K Hangout
- 60 NI News
- 742 Tech Talks
- 3.9K Native Access
- 16K Komplete
- 1.9K Komplete General
- 4.2K Komplete Kontrol
- 5.5K Kontakt
- 1.5K Reaktor
- 367 Battery 4
- 819 Guitar Rig & FX
- 419 Massive X & Synths
- 1.2K Other Software & Hardware
- 5.5K Maschine
- 7K Traktor
- 7K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators