Kontak samples run in DEMO

I have a registered version of Kontak 6. It was upgraded from K-4 and registered. It shows up as registered and it works. However, when I load any of the sounds from the library it has DEMO beside the name in red. I think it runs for a few minutes and stops functioning on that sound.
I've tried everything I know to get it to run in the full function mode like it used to in K-4. And I can't seem to edit the sounds either.
Any ideas on what I need to do to get this back to working correctly?
Best Answer
-
@Guitarhacker I believe the Kontakt 4 Library is not compatible with older versions, you can contact my colleagues here, just to be sure: http://bit.ly/NIsupport_install
0
Answers
-
Check in Native Access if demo is stated for some products.
In this case, have a look at this article
0 -
@Guitarhacker I believe the Kontakt 4 Library is not compatible with older versions, you can contact my colleagues here, just to be sure: http://bit.ly/NIsupport_install
0
Categories
- All Categories
- 21 Welcome
- 757 Hangout
- 73 NI News
- 358 Tech Talks
- 1.6K Native Access
- 7.3K Komplete
- 938 Komplete General
- 1.7K Komplete Kontrol
- 2.7K Kontakt
- 662 Reaktor
- 231 Battery 4
- 400 Guitar Rig & FX
- 265 Massive X & Synths
- 395 Other Software & Hardware
- 3.1K Maschine
- 23 Sampling Room
- 3.8K Traktor
- 3.6K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators