Why can't I use Nano CE blocks?
I have, as far as I can tell, installed the Nano Pack CE files in the right place but when I try to use them they appear in blue and it says they are in demo mode/ that I need to run Native Access. They don't show up in native access to register them.
I'm going mad trying to get these to work. Somebody please help me!
Comments
-
Hello,
you normally also get a key you have to enter in native access first, then you have to go to the not installed tab and hover over the entry, it then shows a glass and you can locate your installation - then it is registered. Those blocks are really great, i only have the free stuff from them but even this is amazing.
Uwe
1 -
Hey Demills. You need to install the Toybox free pack (available on the toybox website) to use the Nano Pack CE pack. See installation instructions for how to do that.
1 -
Thanks, I think I've done this too but I didn't put this in my original post. I'll check again, if still no joy perhaps I could post a screenshot to show you?
0 -
Hi Uwe, thanks for the suggestion. I haven't seen a product key anywhere. Where/ when did that appear for you?
0 -
If i remember correctly I bought the toy box free version for 0 euros and then i've got an email with the serial and the download link.
Uwe
1
Categories
- 4.8K All Categories
- 17 Welcome
- 224 Hangout
- 35 NI News
- 97 Tech Talks
- 426 Native Access
- 2.2K Komplete
- 243 Komplete General
- 476 Komplete Kontrol
- 859 Kontakt
- 242 Reaktor
- 73 Battery 4
- 141 Guitar Rig & FX
- 106 Massive X & Synths
- 84 Other Software & Hardware
- 1.2K Maschine
- 11 Sampling Room
- 1K Traktor
- 861 Traktor Software & Hardware