i have registered the serial of my maschine but i don't see the software in native access

VITO_T · 2025-01-16T09:40:26+00:00

There was an error rendering this rich post.

I bought the mikro mk3 machine and I registered the serial number on native access and so far everything is ok. In my profile among the serial numbers compare that of the machine but in native access the software does not come out

Find more posts tagged with

Maschine Mikro MK3

Accepted answers

Kaiwan_NI

Hi @VITO_T It sounds like your operating system isn't supported. Could you please double-check the system requirements on this page?

https://www.native-instruments.com/en/products/maschine/maschine-accessories/maschine-3/specifications/

Mert_NI

https://community.native-instruments.com/discussion/41391/i-have-registered-the-serial-of-my-maschine-but-i-dont-see-the-software-in-native-access

Hello VITO_T, if your operating sytem is supported, can you please create a support ticket or open a chat support using the link below:

https://bit.ly/NI_support_NA

So our team can help you further with this case.

I hope this helps☺️

All comments