Mapping something (e.g. loop size/out) to jog wheel

This saturday i will set up the Jogwheels for you. I hope it will be exactly what you want.

I am a bit sad the wheels are the only stepless encoders on the S4Mk3 and have been taken out of the overmapping game by NI as well. Time for a remedy.

Thanks for your support. 🦋

Nice. It must have taken a while to get the 3FX-Group values and adjust rates just right. 😁

Is the VCI as rugged as it looks? Gear that can take a beating is so +1 for peace of mind...

NI controllers are a tad minimalistic. With that much mappability i am surprised they didn't add a section of unlabeled knobs and buttons just to make use of this flexibility. ^^

Progress:

Rundown:

• GRID button blinks when active and deck is playing.
• JogLED stops turning to a playing deck, but JogLED turns if wheel gets turned by hand.
• GRID Button toggles MIDI Fader (5-8) from 0.0 to 1.0 and back as a switch. This should provide you with a usable MIDI Out to implement modifiers.
• Also, when using the GRID button as a toggle for JogFX, MIDI Knob value (0.0-1.0) gets reset to 0.0.
• I used the colour RED for both the GRID-Button (Element 1) as well as the TT/Jog-Buttons and JogWheel LED's to provide you with a sample. Any colour works here.
• Turntable mode (motorized) and JogFX mode are now unable to conflict.

This should go some distance to what you want, right? 😎

Thank you again for your support. Glad your are still around being an inspiration for every mapper out there. 🦋

EDIT: There are up to four additional global variables in Traktor that can be used directly both in the qml code as well as in Traktor as a modifier condition in any mapping: RemixDeckPage1-4. If the deck in question is not used as a RemixDeck, then the page of that deck can be manipulated and read without any impact on the deck whatsoever. Just about everbody who uses Traktor has at least two non-RemixDecks in use (Deck A and Deck B mostly), which means two of those universal half-size modifiers are up for grabs.

EDIT2: Should JogTouch reset the MIDI Knob to 0.0 as well, if you let go of the effect and want to restart from zero?

That's possible. Do the following things pose a problem?

• Note 1: If you turn the jogwheel clockwise, the MIDI Knob value will not increase, since 1.000 is the maximum value, unless you turn it counter-clockwise first to go below 1.000.
• Note 2: If you turn the jogwheel counter-clockwise, the MIDI Knob value will decrease and can go down to 0.000, passing 0.500 on the way.
• Note 3: If you turn the jogwheel in any direction without touching the top, the value will deviate from the starting value of 0.500

I can directly assign any fixed value for the MIDI-Knob under any condition, including the condition of the MIDI Knob reaching or crossing a set value, if that is in any way important.

Should i keep the MIDI-Fader switch as an indicator for the GRID toggle and the MIDI-Button toggle as an indicator for TouchON?

Edit: It's possible to have the value jump from 0.000 to 1.000 when turning counter-clockwise and jump from 1.000 to 0.000 when turning clockwise, to have the number change constantly when turning, basically applying modulo 1 on the number.