Is there a way to route the Audio In to the pitch of an oscillator in Reaktor Blocks?

Yes, it is possible to route the audio input to the pitch of an oscillator in Reaktor Blocks. Here's one way to do it:

1. Open Reaktor Blocks and create a new ensemble.
2. Add an audio input module to the ensemble. This will allow you to receive audio input from an external source.
3. Add an oscillator module to the ensemble. This will generate the pitch signal that will be affected by the incoming audio.
4. Connect the output of the audio input module to the input of a level module. This will allow you to control the level of the incoming audio signal.
5. Connect the output of the level module to the input of a pitch follower module. This module will analyze the incoming audio and generate a pitch signal based on its frequency.
6. Connect the output of the pitch follower module to the pitch input of the oscillator module. This will allow the pitch of the oscillator to be controlled by the incoming audio signal.
7. Adjust the settings of the pitch follower module to fine-tune the tracking of the incoming audio. You may also need to adjust the settings of the oscillator module to achieve the desired sound.

With this setup, you can route audio input to the pitch of an oscillator in Reaktor Blocks, allowing you to create dynamic and responsive sounds.

Soo, have you figured it out already, @Emoney? 😅 If not, take a look at this https://deviousmachines.freshdesk.com/support/solutions/articles/43000669533-logic-midi-routing

Do my Audio2Pitch macro works for you?

You can test it with some source music setup within Reaktor - just drag in a factory synth and wire its output to pitch detector inputs, then 'play' it. If that works, then the problem is somewhere else in your system settings. If it doesn't it's the Reaktor code.

Hi,

To have midi infos you need to route the midi signal in the VST Track

How you do it depends of your daw.

In Cubase

• Create the VST instrument track
• Add Reaktor as FX in the insert of the VST Track
• Create a MIDI track
• Leave the midi inputs to all and change the midi out to Reaktor FX input

Now when you go on the midi track and play you have midi signal in Reaktor FX

Optional

If you want to control the VST Instrument and Reaktor

Instead of putting Reaktor FX input as midi out

• Change the midi out to the VST Instrument name
• Go in the midi send effect
• Leave the effect as no effect
• Where there is written not connected change to Reaktor FX input

Now when you are on your midi track and you play you hear the VST Instrument and you still have the midi signal in Reaktor FX

This method can also be used to use one midi channel to control several VST for layering.

If you dont have the tab MIDI Send, right click in the inspector bar and check Midi send. It will appear.

For other daws refer to the manual but it must be similar. It's just a matter of routing the midi signal.

😉