PB w/Traktor's controller manager
Hello community,
After several years away from Traktor I need to bring out my Traktor Pro configuration + personal Maschine MK2 midi template for an event. Unfortunately, I can't get the Maschine MK2 controller recognized in Traktor's controller manager.
I loaded my template (TSI file) in the device part, but in the In-Port and Out-Port part, impossible to select Maschine MK2. Can someone help me? I'm lost, I don't remember very well everything that needed to be done to configure your own mapping and I haven't found any solution anywhere! Could it be related to the USB port or the cable? Knowing that the Maschine is well lit and seems to be recognized by Controller Editor.
I'm on Windows 10, I have the latest version of Traktor Pro (2.11.3.17) same for Controller Editor.
Best Answer
-
The Controller Editor will show templates even with no hardware connected. There is the indicatior though (upper right-side corner) that you can check for outgoing MIDI.
Since you are on a PC go ahead and download latest driver for your unit over at drivers section.
Also try MIDI-OX, just to test the hardware if Traktor still cannot see the ports after the installation.
0
Answers
-
I'm not sure, but have you switched the Machine into midi mode?
0 -
The maschine ports should be visible if driver is installed.
What happens when you click on "None"? Is there a sub menu?
0 -
Hi,
Yes, I did, pressing shift+control. But thank you for your answer, because it might be a maybe it's a silly trick that i forgot to do.
0 -
Hi,
No, if I click on none nothing happen.
I have install a midi clock (loopbe1) and now I can select all ports or loopbe1 internal midi has i/o port, but I still not connect Maschine with Traktor, nothing happen when I push any command.
0 -
I imagine that the driver is installed since I can connect to my Maschine via controller editor. No ?
0 -
The Controller Editor will show templates even with no hardware connected. There is the indicatior though (upper right-side corner) that you can check for outgoing MIDI.
Since you are on a PC go ahead and download latest driver for your unit over at drivers section.
Also try MIDI-OX, just to test the hardware if Traktor still cannot see the ports after the installation.
0 -
It works ! Thanks a lot !!!
0
Categories
- All Categories
- 19 Welcome
- 1.4K Hangout
- 59 NI News
- 723 Tech Talks
- 3.8K Native Access
- 15.5K Komplete
- 1.9K Komplete General
- 4.1K Komplete Kontrol
- 5.4K Kontakt
- 1.5K Reaktor
- 360 Battery 4
- 802 Guitar Rig & FX
- 409 Massive X & Synths
- 1.2K Other Software & Hardware
- 5.4K Maschine
- 6.9K Traktor
- 6.9K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators