How can I view visualizer(level meters) like maschine mk3 on my maschine studio

jedlcz89
jedlcz89 Member Posts: 4 Member
edited October 2024 in Maschine

I have it on mackie control but I can’t seem to find a way to get to the Instance because it’s says that is not connected.

Any help will be appreciated

Thanks

Best Answer

  • D-One
    D-One Moderator Posts: 3,627 mod
    edited October 2022 Answer ✓

    If your referring to this then it's not an option for the Studio (afaik):

    SCR-20221026-mra.jpeg


    But you can have something similar to this:

    SCR-20221026-mtk.jpeg

    Inside Logic open the Control Surface Setup and ensure you're using the correct MIDI ports under the Mackie Control Icon.


    https://community.native-instruments.com/discussion/comment/36876#Comment_36876

    It is. What you're referring to is the "DAW Control Mode" (I think), Mackie emulation is something different, basically pic-1 VS pic-2.

Answers

  • Kubrak
    Kubrak Member Posts: 3,093 Expert

    You may see level meters on Studio like on MK3, if it is connected using "NI protocol". Not sure if it is possible if using mackie controll protocol. Might also depend on DAW.

  • jedlcz89
    jedlcz89 Member Posts: 4 Member
    edited October 2022

    Im using Logic Pro x

    inside my Daw, my maschine studio can’t seem to find the displayed levels meters and I already did mackie control. Mk3 has the option to do so

  • D-One
    D-One Moderator Posts: 3,627 mod
    edited October 2022 Answer ✓

    If your referring to this then it's not an option for the Studio (afaik):

    SCR-20221026-mra.jpeg


    But you can have something similar to this:

    SCR-20221026-mtk.jpeg

    Inside Logic open the Control Surface Setup and ensure you're using the correct MIDI ports under the Mackie Control Icon.


    https://community.native-instruments.com/discussion/comment/36876#Comment_36876

    It is. What you're referring to is the "DAW Control Mode" (I think), Mackie emulation is something different, basically pic-1 VS pic-2.

  • jedlcz89
    jedlcz89 Member Posts: 4 Member

    Thank you I really appreciate it. That’s exactly what I was asking. I see that is not possible.

This discussion has been closed.
Back To Top

Categories