Using a midi foot controller with Mas+

kleody
kleody Member Posts: 13 Newcomer
edited September 2022 in Maschine

Has anyone had any luck using a midi foot controller like Nektar pacer... to expand the looping capacity of the Maschine+ ?

Tagged:

Comments

  • D-One
    D-One Moderator Posts: 1,496 mod
    edited September 2022

    Hum... Something like that is too fancy, you can't MIDI Map the record/play button in Maschine, however the simpler footpedals with just 2 signals (Tip and Ring via the Sustain Input in the back) work in all modern Maschine controllers but... it's configured via Controller Editor so I am not sure if this works on the M+ or not.

    Something like this:

    https://www.youtube.com/watch?v=cOChpRPlCG8

    I'm not 100% sure but I think @ozon has tried this.

    EDIT: The manual says a simple Footswitch should work, page 210.

  • ozon
    ozon Member Posts: 781 Guru
    https://community.native-instruments.com/discussion/comment/33353#Comment_33353

    Unfortunately, I don’t remember… and the old forum is currently down… 😟

  • kleody
    kleody Member Posts: 13 Newcomer

    Thanks for reply! I kind of thought it might not be an easy solution- I will try the fs-6 and see if the compromise is ok though... cheers!

Back To Top

Categories