How to edit Modulation amount in Step view for Audio device
I'm trying to modulate a parameter on a Sound with an Audio device in Step view on the Maschine controller. However, when I hold down the step for the Audio in Step view it makes the Audio step delete when I remove my finger. This is a very different behavior from all other devices with like Sampler device or any other one.
Best Answer
-
When the audio Module is in Gate mode, pressing an event (lit pad) in step mode deactivates the audio Module. What happens when you use Loop mode?
0
Answers
-
When the audio Module is in Gate mode, pressing an event (lit pad) in step mode deactivates the audio Module. What happens when you use Loop mode?
0 -
Thanks for the tip. I was actually using Loop mode to where it doesn't allow me to enter a modulation on a per step basis.
I switched it to Gate mode and it actually works that way. I guess it's either a bug or an oversight for it not to work in Loop mode? Unless there is some other way we're not seeing.
0
Categories
- 12.2K All Categories
- 21 Welcome
- 559 Hangout
- 68 NI News
- 270 Tech Talks
- 1.2K Native Access
- 5.7K Komplete
- 749 Komplete General
- 1.3K Komplete Kontrol
- 2.1K Kontakt
- 565 Reaktor
- 184 Battery 4
- 314 Guitar Rig & FX
- 221 Massive X & Synths
- 267 Other Software & Hardware
- 2.6K Maschine
- 24 Sampling Room
- 3.1K Traktor
- 2.8K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators