S4MK3 & S3: Community Performance MOD (qml coding)

Sûlherokhh · June 7

https://community.native-instruments.com/discussion/comment/229785#Comment_229785

return the qml files to their original 4.2 state.
test if it works now (default mapping); if not, there is your problem.
now put the mod files on top. Your OS will ask to replace 21 files.
test if it works now.

hardbea7 · June 8

https://community.native-instruments.com/discussion/comment/201232#Comment_201232

@Wonton

You have to go into each folder under QML, and replace them

NLaboske · June 10

Hi there,

Been using this mod since the day I got my S4mk3, so thank you very much for providing this for us 🙏

I'm wondering if it's possible for the mod to have the controller displays show parameters from the FX units when adjusted. I like to use my effects in a group (often delay and lfo among others) and it's tricky planning an echo out to have the intended effect because the Traktor software doesn't display parameters for effects when the module is in group mode, only a 1-100 value. So it's hard to distinguish a 2/4 echo from a 3/4 echo before it plays out.

Thanks!

Sûlherokhh · June 10

https://community.native-instruments.com/discussion/comment/230105#Comment_230105

It's on my to-do list. Still working on remix controls expansion and remix/stem controls via FX knobs/buttons. May take a bit, as i would have to adapt the D2/S8 pop-up elements, in particular the parameter display variations, for the S4 screens.

Noted. :)

VDJ303 · June 12

Hi. I'm using Version 9 Beta 4 and realized one feature is not working anymore on my S4MK3:

Jogwheel Turn: (while in active Loop) holdRec or Mute (or both) to adjust Loop-In or Loop-Out (or both) …

Is it a know issue? I also restarted everything. With Version 8 it was working as expected…

Sûlherokhh · June 12

https://community.native-instruments.com/discussion/comment/230442#Comment_230442

I'm using beta5 and it's working as it should.

Try (re-)installing beta5, after going back to the original, unaltered (saved) qml files instead of using beta4 and tell me if it works now.

Sûlherokhh · June 13

https://community.native-instruments.com/discussion/comment/228702#Comment_228702

I have an idea of how to do this, if you are still interested. I have put it on my Maybe-To-Do list. There won't be any GUI feedback though.

For those interested in codework, if it works at all, it would work with another parameter (per knob) between the hardware position value and the software equalizer value, which only align without holding down SHIFT and which are forcibly aligned when releasing SHIFT.

Note: I am working on the next beta now (Remix and Stem stuff currently).

VDJ303 · June 13

https://community.native-instruments.com/discussion/comment/230450#Comment_230450

Thanks for the hint… After reinstalling Beta5, it is working again!

S4MK3 & S3: Community Performance MOD (qml coding)

Comments

Categories