S4MK3 & S3: Community Performance MOD (qml coding)

1…434445464749»

Comments

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 3,566 mod
    https://community.native-instruments.com/discussion/comment/229785#Comment_229785
    1. return the qml files to their original 4.2 state.
    2. test if it works now (default mapping); if not, there is your problem.
    3. now put the mod files on top. Your OS will ask to replace 21 files.
    4. test if it works now.
  • hardbea7
    hardbea7 Member Posts: 28 Member
    https://community.native-instruments.com/discussion/comment/201232#Comment_201232

    @Wonton

    You have to go into each folder under QML, and replace them

  • NLaboske
    NLaboske Member Posts: 10 Member

    Hi there,

    Been using this mod since the day I got my S4mk3, so thank you very much for providing this for us 🙏

    I'm wondering if it's possible for the mod to have the controller displays show parameters from the FX units when adjusted. I like to use my effects in a group (often delay and lfo among others) and it's tricky planning an echo out to have the intended effect because the Traktor software doesn't display parameters for effects when the module is in group mode, only a 1-100 value. So it's hard to distinguish a 2/4 echo from a 3/4 echo before it plays out.

    Thanks!

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 3,566 mod
    https://community.native-instruments.com/discussion/comment/230105#Comment_230105

    It's on my to-do list. Still working on remix controls expansion and remix/stem controls via FX knobs/buttons. May take a bit, as i would have to adapt the D2/S8 pop-up elements, in particular the parameter display variations, for the S4 screens.

    Noted. :)

  • VDJ303
    VDJ303 Member Posts: 2 Newcomer

    Hi. I'm using Version 9 Beta 4 and realized one feature is not working anymore on my S4MK3:

    Jogwheel Turn: (while in active Loop) holdRec or Mute (or both) to adjust Loop-In or Loop-Out (or both) …

    Is it a know issue? I also restarted everything. With Version 8 it was working as expected…

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 3,566 mod
    https://community.native-instruments.com/discussion/comment/230442#Comment_230442

    I'm using beta5 and it's working as it should.

    Try (re-)installing beta5, after going back to the original, unaltered (saved) qml files instead of using beta4 and tell me if it works now.

Back To Top

Categories