How to Route 3 Different Instruments? (1is maschine+)

nhs
nhs Member Posts: 2 Newcomer
edited October 22 in Maschine

Hi everyone ,recently I've bought an arturia beatstep pro to route my maschine and my moog dfam. But it seems i cant figure out how to make it at the right tempo. I would like to use the arturia as a master clock, the maschine for the synths and dfam for the drums.

If someone knows how to route it the best way let me know

thanks

Tagged:

Comments

  • ozon
    ozon Member Posts: 1,758 Expert
    edited August 13

    I can’t help you in detail with that setup because out of the three I only have the M+.

    However, here are some general tips:

    • Make sure your M+ is running on Firmware 0.1.9. It fixes a couple of MIDI related bugs introduced by 0.1.6.
    • Some users report that the M+ doesn’t sync very well to MIDI clock. Either use the M+ as master clock, or use Ableton Link instead of MIDI. I guess both isn’t feasible with your specific selection of devices.
    • There are a couple of threads about M+ and MIDI sync, which might contain some information applicable to your setup.

  • nhs
    nhs Member Posts: 2 Newcomer

    thank u very much <3

  • Psyearth5
    Psyearth5 Member Posts: 316 Member
    https://community.native-instruments.com/discussion/comment/171745#Comment_171745

    As Master M+ is better but it depends on other devices protocols.

  • tetsuneko
    tetsuneko Member Posts: 766 Expert

    I am using my M+ as a USB MIDI clock slave, and it syncs up well enough IME. Beatstep doesnt send MIDI clock over USB now does it? If not, I'd use M+ as the clock master, and supply the clock to beatstep over DIN MIDI

This discussion has been closed.
Back To Top

Categories