Traktor FX Specialists needed

macsoft
macsoft Member Posts: 119 Member
edited October 2024 in Traktor Software & Hardware

When Traktor FX is in single mode, we can tweak 3 parameters on the effect.

When we switch to Group Mode, we get 3 FXs but only one parameter tweaking for each.

So if my first FX is DELAY, how to retain the single mode settings when switching to Group Mode? Because it never retains it.

thanks

Comments

  • Stevan
    Stevan Traktor Mapping Mod Posts: 2,130 mod

    It sounds like the effect is going back to it's original snapshot, you can tweak values and then save a new snapshot within the FX Unit in Traktor.

  • macsoft
    macsoft Member Posts: 119 Member
    https://community.native-instruments.com/discussion/comment/166317#Comment_166317

    No, the snapshop works greak in single mode. and in single mode i wanna tweak all 3 parameters. But when i change to Group Mode, i can only tweak one, and the rest should stay as they were in single mode, and they dont. I can't tweak the rest in group mode

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 2,996 mod

    In Group mode you can only adjust a single parameter, which is different for every FX (check the manual that lists all FX and specifies what group mode does for it). All other parameters have a fixed value which the user can't access or change.

    MANUAL (FX SECTION)

  • Isotoxin
    Isotoxin Member Posts: 212 Advisor
    edited July 2024

    As a workaround, chain the needed amount of FX decks in settings with all effects selected in single mode. You will have all the parameters and a chained group of effects. Up to 4 effects (because of 4 FX decks).

This discussion has been closed.
Back To Top

Categories