How can I connect the master of the Traktor S3 to the inputs (1/2) of the Komplete Audio 6 mk2?

rocmusik · 2024-07-08T18:52:39+00:00

There was an error rendering this rich post.

I bought some new studio monitors and a subwoofer (KRK cssc 7, and s8.4 sub). Now I want to connect the master of my Traktor S3 and listen to it through my monitors without having to change the input on the sub every time. I have the Komplete Audio 6 mk2 and ive connected the trakor master to inputs 1/2, but I cannot hear it from the monitors, it is only allowed in the headphone pre-listening.

I read an article that I need a DAW to do this, the problem is that when I listen from Ableton there is a lot of delay.

I hope I have explained well,
Thanks in advance

Find more posts tagged with

Traktor Pro 3

Accepted answers

All comments

Kubrak

I assume you take analog out from S3 and lead it to analog in in KA6. Right?

Why do you not set output from Traktor SW directly to KA6? Would be easier, less latency, less cables and so on…

rocmusik

https://community.native-instruments.com/discussion/comment/164003#Comment_164003

@Kubrak thanks for the reply!

I have tried configuring the output directly from Traktor but the application settings change, that is, the audio comes out correctly but I cannot control the program with the mixer.

Could you explain to me how to configure it?
Thanks again.

Kubrak

@rocmusik

Hard to say, it should work. One just changes audio output to different audio interface (KA6 in your case)…

Can you past screenshot of audiosetup in Traktor, here?

Martiniix_NI

Heyo!

can you help us with some photos and screenshots from your setup?

Martiniix_NI

Any update? @rocmusik

Quick links

Unanswered questions