How to setup second K2 on a traktor 3?

I have 2 k2s. They are using x link. I can get the first k2 working using the Allen and Heath TSI mapping file. It’s on midi channel 14. For the second K2 it can’t control decks c and d. I can’t seem to find the next step to get the second K2 working. Second K2 is on midi channel 13.
Answers
-
I heard that the trick was not to chain them in sequence. But i am not sure since i only own a single K2.
0 -
I tried just plugging the second k2 in via usb. Still did not work. I then tried it by is itself and it looks like the mapping I’m using is designed for midi channel 14. How would I change it to work on a different midi channel?
0 -
Get the cmdr editor (command manager done right), maintained by @dj_estrela.
You can find the old forum thread here and download the editor from here.
[Edit: The new thread]
Follow the installation instructions. Once set up, load the complete mapping pack into the editor. Mark all lines of commands from the mapping page (Ctrl+A). On the right side should be a pane where you can change the channel for all lines simultaneously. Do this for every page in the mapping pack. There could be 2 or more, if it's one of those really elaborate mappings.
3 -
Thanks! I will see where I get with this.
1
Categories
- All Categories
- 21 Welcome
- 746 Hangout
- 73 NI News
- 353 Tech Talks
- 1.6K Native Access
- 7.2K Komplete
- 936 Komplete General
- 1.7K Komplete Kontrol
- 2.6K Kontakt
- 656 Reaktor
- 229 Battery 4
- 394 Guitar Rig & FX
- 263 Massive X & Synths
- 390 Other Software & Hardware
- 3.1K Maschine
- 25 Sampling Room
- 3.8K Traktor
- 3.5K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators