Greets:
I'm on Maschine MK3, going through the NI Accessibility Helper tutorial video that NI made awhile back.
I'm at the section where I am using the Sampler plugin. I am using manual slicing for a loop, which populates the pads. I then adjust the start and end points, and then Apply. I am doing this all on the MK3 hardware.
I had to quit and then open Maschine 3 when I had time. The group still has the single loop, but for some reason I do not see the slices I made. This happened twice. There was one time when I saw the slice markers, but no sample, and then the next time the reverse.
I am clearly missing something. My expectation is that when Isave my project, the next time I open it, I should see the sliced pads. Instead, I see only one pad with the single sample. When I enter slice mode, the pad turns blank.
I'd appreciate some guidance on how to prevent this from happening. Thank you.
