Recording a mix with Traktor Pro 4

Twoure

Hi everyone,

I’m trying to record a DJ set in Traktor Pro 3, but I’m running into an audio recording problem. My current setup uses 2 × Xone controllers and 1 × Xone, connected to a Xone:92 mixer.

The mix plays normally through the system, but when I start recording, the resulting file has no audio at all. I also don’t see any signal level or meter activity in Traktor’s recording section while the set is running.

I’ve checked the basic audio connections and routing, slope but I can’t figure out what I’m missing. Has anyone used a similar setup and can explain how the recording input should be configured in Traktor Pro 3?

Any advice on the correct audio routing or recording settings would be greatly appreciated. Thanks!

lord-carlos

You have to send the audio back to the computer form the mixer. Connect a cable from the xone 92 record out back into the same audio interface that you already use with traktor.

Here is a small guide: https://support.native-instruments.com/support/solutions/articles/69000879478-how-to-record-a-mix-in-traktor-using-an-external-mixer-and-the-audio-8-dj

Alternative you can buy a small recorder that you connect to the xone.