Rotary encoder values when using Maschine MK3 as MIDI controller with Cubase 14

Low Mantra

I've started using Maschine MK3 via MIDI Remote in Cubase Pro 14 to control some parameters.

It is working OK but the displays on Maschine don't reflect the values in Cubase.

For eample, I'm using a rotary encoder to set the pre gain. I set the value in Cubase to -6.4db but the display in the screen above the encoder says 55.

I've looked in Cubase and also the controller editor to try and discover if there is a setting I'm missing or even if it can be done at all.

Any ideas if this can be solved?

TIA

Andrew

Uwe303

Hello,

maschine just shows the midi values, only way to have the actual parameter values is to use maschine with the mackie protocol, fortunately it´s implemented in maschine. I also own the mk3 but have not made a mackie template yet like i have for my maschine studio. If i have some time i can make one, then you can use the quick controls, and have the parameter values on the screen.