about sync of the oscillator module

movin10000 · 2025-07-17T16:41:43+00:00

There was an error rendering this rich post.

I have a question about the sync of the oscillator module in a Reaktor6 ens file.

I placed multiple oscillators in MACRO1, and another in MACRO2.

I then implemented a hard sync function by connecting the waveform output from Macro2 to the sync of the MACRO1 waveform, but after a while the synth stops working, with the output still outputting a maximum volume signal.

If I mute and unmute it from STATUS, it starts working again.

Are there any points to be careful about when using hard sync? Is there a way to solve this?

Is it possible that this could happen if too much load is put on it?

Find more posts tagged with

Reaktor 6

Accepted answers

All comments

colB

It's most likely something else in your code that causes the issue.

Maybe somewhere you are getting a divide by zero? Or some similar cause of inf or NaN...

Difficult for anyone to help when you just post a cropped pic with no wider context

Quick links

Unanswered questions