Event breakpoint shaper

The breakpoint shaper only seem sto work adequatly when the input range is 0-1
Choose the 4 breakpoint point shaper , and set values to 0 0.25 0.5 0.75 1 , this resembles a straight linear line .
When input range is 0 - 128 , only the two last breakpoint have any effect
First giff ,an iterator ( 0-128 ) ouput divided by 128 into the breakpoint and into a multidisplay ( y range 0-1 ) , works fine ,
Second giff , output iterator not divided into breakpoint then into event table ( y range 0-128 ) .
Notice how only the last two parametrs of the breakpoint have any effect
UNless I am missing the point
Event table , output iterator NOT divided , event Y-range 0-128
Comments
-
UNless I am missing the point
Read the info for the module and the tool tips for the individual inputs.
It clearly specifies an input range from 0 to 1
0 -
Fair enough
0 -
The iterator is outputting whole values right from the start, so it's only reading the "1" value from the value shaper.
Try connecting the divide module to the output of the iterator and divide by the number of iteration values, in this case that looks to be 128.
Connect the iteration output to the top of the divide module, and the "128" to the bottom, and then connect the divide output to the shaper "In" port.
0 -
Y s I am aware of that , hence why I divided the output and it works fine
I didn''t know the bp shaper was working in range 0…1 only0
Categories
- All Categories
- 18 Welcome
- 1.7K Hangout
- 67 NI News
- 895 Tech Talks
- 4.6K Native Access
- 17.8K Komplete
- 2.2K Komplete General
- 4.8K Komplete Kontrol
- 6.3K Kontakt
- 1.1K Reaktor
- 407 Battery 4
- 923 Guitar Rig & FX
- 467 Massive X & Synths
- 1.5K Other Software & Hardware
- 6.4K Maschine
- 8.2K Traktor
- 8.2K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators