Maschine mk1 and generic usb cable
The theme here is mk1 is old and getting dusted off after years. i connect with a 5 meter usb cable to a newer laptop on a usb 3.0 port. the buttons and screen light up and turn off quickly on maschine. next windows says the usb device has a problem and cannot be recognized. However, when i connect with same cable to a linux laptop it does identify itself correctly (but also doesn't stay on)
is the problem not enough power or something going on with the device?
Best Answer
-
i should mention the original cable was definitely bad, so i replaced it with this new longer one.
In a situation like this then you ought to test using a short cable that you know is OK
0
Answers
-
I don't think it is a matter of USB.
Are you sure that its driver is installed?
Maschine MK1
0 -
yep downloaded and installed/reinstalled via Maschine_Controller_301_PC_p.exe
0 -
i should mention the original cable was definitely bad, so i replaced it with this new longer one.
0 -
i should mention the original cable was definitely bad, so i replaced it with this new longer one.
In a situation like this then you ought to test using a short cable that you know is OK
0 -
Shorter cable solved the issue thanks.
1 -
Thank you for providing feedback and for sharing the solution 🙂
0
Categories
- All Categories
- 19 Welcome
- 1.6K Hangout
- 65 NI News
- 842 Tech Talks
- 4.3K Native Access
- 17.3K Komplete
- 2.1K Komplete General
- 4.5K Komplete Kontrol
- 6K Kontakt
- 1.6K Reaktor
- 394 Battery 4
- 882 Guitar Rig & FX
- 445 Massive X & Synths
- 1.4K Other Software & Hardware
- 6.1K Maschine
- 7.7K Traktor
- 7.7K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators