Komplete Kontrol S88 MK1 and Maschine 3

Civil

is there a possible work around for getting my Komplete Kontrol S88 MK1 to work as intended with Maschine 3? It works perfectly fine with Maschine 2 but then just functions as a regular MIDI with none of the functionality that made this thing cost me so much money in the first place in Maschine 3.

Jeremy_NI

https://community.native-instruments.com/discussion/42819/komplete-kontrol-s88-mk1-and-maschine-3

The Komplete Kontrol mk1 reached end of support, you can read about it here: Notes on Ending Software Support for Komplete Kontrol S-Series MK1 Keyboards

It will never be supported in Maschine 3. You can still use it with Maschine 2.

Vocalpoint

https://community.native-instruments.com/discussion/42819/komplete-kontrol-s88-mk1-and-maschine-3

You will need to use Komplete Kontrol v2.9.6 with any MK1 controller. (s49, s61 or s88)

If you have installed Komplete Kontrol v3.x (any version) - this is why you have lost all control. This version of KK is not supported by MK1 boards

VP

ALDREAD

it’s not officially supported in maschine 3

Why do you use maschine 3 over maschine 2 ?

Jeremy_NI

https://community.native-instruments.com/discussion/42819/komplete-kontrol-s88-mk1-and-maschine-3

The Komplete Kontrol mk1 reached end of support, you can read about it here: Notes on Ending Software Support for Komplete Kontrol S-Series MK1 Keyboards

It will never be supported in Maschine 3. You can still use it with Maschine 2.

Civil

https://community.native-instruments.com/discussion/comment/213122#Comment_213122

Now that I think about it, really only for the stem Separation. I guess I can just stem separate, bounce and then open the files up in Maschine 2, since I really only use it sparingly anyway. It just sucks that I can't open any of my Maschine 3 saves in Maschine 2. I was making a lot of beats on the move and didn't notice my keyboard wasn't supported because I was mostly using my MaschineMK3. Thanks though! i guess I'll worry about Maschine 3 when there's actually an update worth migrating to.

ALDREAD

https://community.native-instruments.com/discussion/comment/213686#Comment_213686

no probs , that was my logic behind asking,

maybe you could try dragging and dropping

I’ve just had a test run dropping midi patterns from 3 to 2 , just drag to the piano roll

I know what you’re thinking , what about my groups or sounds I made

Well groups seem to be a no go , if I try to open a m3 group m2 crashes but ………..

Sounds do work , save a sound in maschine 3 , open it in m2 , I did it by dragging it to a sound slot from the m3 sound folder , cause I didn’t set up a shortcut to the folder , which is probably doable

Dragging Sound worked fine , fx chain and the samples / Rex file was intact

Hope that helps

Civil

https://community.native-instruments.com/discussion/comment/213693#Comment_213693

thanks yeah this is helpful for anything I want to finish in Maschine 2. And I mostly use separate groups for each sound I use outside of drum kits so it’ll be easy to save the Sounds and migrate them to Maschine 2