Traktor Pro3 & drivers doesnt work (s2mk3)

KvartalScar

Everything was fine, I left my controller (s 2 mk3) for three weeks, turned on, connected and started traktor pro 3. Ace seems to start, but after one click, the message does not respond appears in parentheses and eventually crashes. Following advice from the Internet, I started reinstalling the drivers, but when ASIO starts, it gives an error. I deleted everything from Native Instruments and even the driver. It worked fine once, then it happened again. I have installed the ASIO driver installer, it gives an error after startup.

Uwe303

Hello,

does traktor work without the s2 connected, maybe play something through the build in audio interface through the laptop speakers. Also try to use chkdsk /r

https://www.avg.com/en/signal/how-to-use-chkdsk-windows#:~:text=Run%20CHKDSK%20from%20Command%20Prompt&text=Type%20cmd%20(or%20command%20prompt,for%20problems%20without%20making%20changes.

And check ram like this:

https://cleanerone.trendmicro.com/blog/check-for-ram-on-windows-10-and-11/#:~:text=Step%201%3A%20Press%20the%20Windows,proceed%20with%20the%20diagnostic%20test.

Also sfc /scannow

https://www.dell.com/support/kbdoc/en-us/000126064/how-do-i-run-the-system-file-checker-in-microsoft-windows

Redownload the driver after the checks and try to reinstall them, without the device connected as far as I know, after installation you can connect the device.

Uwe303

Hello,

does traktor work without the s2 connected, maybe play something through the build in audio interface through the laptop speakers. Also try to use chkdsk /r

https://www.avg.com/en/signal/how-to-use-chkdsk-windows#:~:text=Run%20CHKDSK%20from%20Command%20Prompt&text=Type%20cmd%20(or%20command%20prompt,for%20problems%20without%20making%20changes.

And check ram like this:

https://cleanerone.trendmicro.com/blog/check-for-ram-on-windows-10-and-11/#:~:text=Step%201%3A%20Press%20the%20Windows,proceed%20with%20the%20diagnostic%20test.

Also sfc /scannow

https://www.dell.com/support/kbdoc/en-us/000126064/how-do-i-run-the-system-file-checker-in-microsoft-windows

Redownload the driver after the checks and try to reinstall them, without the device connected as far as I know, after installation you can connect the device.

KvartalScar

I did everything that was indicated. In the end, everything remained the same, when starting the drivers, it gives an error, Traktor Pro 3 does not work and without a controller too, it starts and if you click it says re responds.

KvartalScar

I did everything that was indicated. In the end, everything remained the same, when starting the drivers, it gives an error, Traktor Pro 3 does not work and without a controller too, it starts and if you click it says re responds.

https://community.native-instruments.com/discussion/comment/213242#Comment_213242

Uwe303

Then I don't know any further, of you have checked the disk and ram and all tests passed. Maybe a fresh windows install is an option, even if it might not help. You could try to use a virus scanner:

https://www.malwarebytes.com/mwb-download

You maybe have to contact native instruments support.