Maschine 3.0 does not start after scanning process

Basti0228

Hi, I purchased the new Update 3.0. It started once, but after loading a project that was created in 2.0 the software crashed and did not start since. Now, the first window pops up but just vanishes after "Initializing Gui". I am new here, sorry if this question is located in the wrong place.

Thank you!

Best

ALDREAD

https://community.native-instruments.com/discussion/41492/maschine-3-0-does-not-start-after-scanning-process

what it’s probably trying to do is auto load that project , try removing it it from the maschine 2 project folder

ALDREAD

https://community.native-instruments.com/discussion/41492/maschine-3-0-does-not-start-after-scanning-process

what it’s probably trying to do is auto load that project , try removing it it from the maschine 2 project folder

Basti0228

Thank you! That worked.