Kontrol S2 Mk3 - Stem volume mapping

Jazzzifrizzle
Jazzzifrizzle Member Posts: 4 Newcomer
in Traktor Software & Hardware

Has anyone managed to map the Kontrol S2 Mk3 for the volume control of stems in TP4? and if so can you share the ways in which you mapped the midi controller

Tagged:

Best Answer

Answers

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 3,473 mod
    Answer ✓
    https://community.native-instruments.com/discussion/41320/kontrol-s2-mk3-stem-volume-mapping

    S2MK3 already has Stem volume controls, although the manual does not advertise this.

    Load a Stem file.

    Press SAMPLES.

    You are now in PadMode.Stems

    Top 4 pads control mute.

    Bottom 4 pads are HOLD buttons. If you hold one of them down, you can use the MOVE encoder to adjust volume and the LOOP encoder to adjust FILTER. If you press the encoders, you reset the values (100% for volume, +/- 0% for filter.

  • trea
    trea Member Posts: 5 Newcomer

    Great!!! Now is there a way to control stem filters thru a S2 MK3?

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 3,473 mod
    edited April 27
    https://community.native-instruments.com/discussion/comment/223791#Comment_223791

    :)

    Let me repeat:

    Load a Stem file.

    Press SAMPLES.

    You are now in PadMode.Stems

    …

    Bottom 4 pads are HOLD buttons. If you hold one of them down, you can use the MOVE encoder to adjust volume and the LOOP encoder to adjust FILTER. If you press the encoders, you reset the values (100% for volume, +/- 0% for filter.

    Edit: This is for the four stem subchannels. This is what you where looking to adjust, right?

Back To Top

Categories