Bar visualisation of parameters in midi mode
I used to use the original mk 1 (now using mk3) and it had an option when you press shift in midi mode, display parameters as values or bar. I can't seem to find this anywhere now, is it possible to activate?
Best Answers
-
Holding Shift works for me with the M+ and as far as I remember it worked the same in the MK3, what shows up for you guys when you hold Shift?
1 -
Nothing was showing up when pressing shift, but then I figured out the problem - I had to activate the knobs and pads pages in the controller editor. Now it works as it should. Thanks, the photo helped to know there must be a solution 😊
1
Answers
-
Hello,
seems to be gone in editor too for mk3, my studio still has the option.
0 -
Holding Shift works for me with the M+ and as far as I remember it worked the same in the MK3, what shows up for you guys when you hold Shift?
1 -
Nothing was showing up when pressing shift, but then I figured out the problem - I had to activate the knobs and pads pages in the controller editor. Now it works as it should. Thanks, the photo helped to know there must be a solution 😊
1
Categories
- 10.8K All Categories
- 22 Welcome
- 450 Hangout
- 59 NI News
- 209 Tech Talks
- 1.1K Native Access
- 4.9K Komplete
- 623 Komplete General
- 1.1K Komplete Kontrol
- 1.9K Kontakt
- 491 Reaktor
- 157 Battery 4
- 271 Guitar Rig & FX
- 203 Massive X & Synths
- 213 Other Software & Hardware
- 2.3K Maschine
- 14 Sampling Room
- 2.6K Traktor
- 2.4K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators