No graphics card support for stem conversion ?
I have the latest version of Traktor Pro 4 and an Nvidia RTX 1050 graphics card. The system requirements for Traktor Pro 4 state that you should have a powerful graphics card with OpenGL 2.1 or higher. My graphics card even supports 4.6, but even so, when creating stems, only the processor is used. This means it takes a long time and nothing can be done in parallel. Do I need to change something in the settings and if so, where? Or am I missing a suitable driver or additional component? I've already tried the Studio driver and the Game Ready driver. No difference.
Thank you in advance for your answers.
Best Answer
-
Nope, traktor sadly does not use gpu for stem separation. Let's hope they add it at some point.
1
Answers
-
I have found no information anywhere that says that Traktor Pro 4 supports any kind of GPU acceleration support for Stem file generation. On the contrary then the manual does not mention GPU support at all, and neither is it mentioned in the 'What's new' either. So despite that this or that software might offer GPU support for conversion or encoding then if not specifically mentioned as available then I do not think that you should expect it to be supported.
0 -
Nope, traktor sadly does not use gpu for stem separation. Let's hope they add it at some point.
1
Categories
- All Categories
- 19 Welcome
- 1.5K Hangout
- 62 NI News
- 785 Tech Talks
- 4.1K Native Access
- 16.5K Komplete
- 2K Komplete General
- 4.3K Komplete Kontrol
- 5.7K Kontakt
- 1.6K Reaktor
- 378 Battery 4
- 845 Guitar Rig & FX
- 429 Massive X & Synths
- 1.3K Other Software & Hardware
- 5.8K Maschine
- 7.3K Traktor
- 7.3K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators