NI Maschine MIKRO MK3 software problems appear, who can give the anwser!

WENHE

It's not compatible with Studio One6 platform? is it true? when i press this two button, the studio one6-maschine2 as VST, play and stop can't work in maschine2 !!!

D-One

You have to enable "Host Transport Control" in the Controller Editor app, then Maschine sends MIDI thru the transport section instead of controlling it's own software.

You also need to make sure you load a Mackie/MCU control template in CE and configure S1 to use Maschine HW as a Mackie device:

Guide link here:

https://support.native-instruments.com/hc/en-us/articles/360012819498--Setting-up-Your-Maschine-Controller-for-Host-Transport-Control-in-Studio-One

D-One

You have to enable "Host Transport Control" in the Controller Editor app, then Maschine sends MIDI thru the transport section instead of controlling it's own software.

You also need to make sure you load a Mackie/MCU control template in CE and configure S1 to use Maschine HW as a Mackie device:

Guide link here:

https://support.native-instruments.com/hc/en-us/articles/360012819498--Setting-up-Your-Maschine-Controller-for-Host-Transport-Control-in-Studio-One

WENHE

https://community.native-instruments.com/discussion/comment/162724#Comment_162724

Thanks for D-one's instant feedback, I operates it as you said, the red parts work, but orange parts become OFF, how do i enable the maschine function about the orange marked parts as below? I still need your assistance!

D-One

https://community.native-instruments.com/discussion/comment/162979#Comment_162979

Create a "New Template" then just change the Transport Section highlighted in green to "MCU" buttons on the "Assign" page, if you click the Parameter ID and move the mouse it will scroll and show what it does on the button name.

• Record = 0
• Play = 94
• Loop = 86
• etc…

Then change the Orange part to do whatever it is you want to do, but the orange part only applies to MIDI Mode, not while controlling Maschine SW/Plug. It doesn't make much sense to control maschine SW with the controller in MIDI Mode, you lose a ton of functionality and basically turn it into a dumb MIDI device as opposed to a dedicated one.

WENHE

https://community.native-instruments.com/discussion/comment/163075#Comment_163075

Thanks a lot, professional