Swap channel Traktor Kontrol S4 mk3

gpratola

Hi everyone
I would like to change the channel assignment on my S4 mk3
I have already performed the map overload of all knobs, effects etc... and everything is ready
BUT I can't find a way to swap the channels audio routing ,

I set the input routing, but nothing, the audio doesn't come out of the correct channel, how can you do it

I would like a classic channel configuration 1 A - channel 2 B - channel 3 C and channel 4 D. (I don't want A and B in the center)

Thank you can help me

maniacintosh81

Input routing setup only affects the physical external inputs not internal routing. If you play with the internal decks this shouldn't be needed at all. Mapping the left fader to control deck A should sufficient (and remapping all the other channels.)

But as S4 Mk3 works in HID mode and not as MIDI controller; I am not sure if you can overmap the controls in mixer section at all. You may have to edit the .qml-File for S4 Mk3. But don't ask me how to do this, never done this myself.

maniacintosh81

With S4 Mk3 Traktor Pro does mixing of its own decks internal in software. Traktor just sends this mix to the audio interface in S4 Mk3 not signals of the single decks.

As written the Input routing only sets up where signals supplied on S4 Mk3s external inputs are routed to.

Not sure if it is possible to change VU meters in the qml file. You may contact @Sûlherokhh here in the community. He supplies the performance mod for S3 and S4 Mk3 and assume he speaks qml fluent therefore.

maniacintosh81

Input routing setup only affects the physical external inputs not internal routing. If you play with the internal decks this shouldn't be needed at all. Mapping the left fader to control deck A should sufficient (and remapping all the other channels.)

But as S4 Mk3 works in HID mode and not as MIDI controller; I am not sure if you can overmap the controls in mixer section at all. You may have to edit the .qml-File for S4 Mk3. But don't ask me how to do this, never done this myself.

gpratola

Yes, the overmap works correctly

the problem is that the volume meters cannot be changed, so the configuration is not good !!! when I play on deck C ( now with A Volume adjust ) I see the volume meter always on Deck A ….

I thought it was possible to change the audio routing as happens in almost all mixers. :(

maniacintosh81

With S4 Mk3 Traktor Pro does mixing of its own decks internal in software. Traktor just sends this mix to the audio interface in S4 Mk3 not signals of the single decks.

As written the Input routing only sets up where signals supplied on S4 Mk3s external inputs are routed to.

Not sure if it is possible to change VU meters in the qml file. You may contact @Sûlherokhh here in the community. He supplies the performance mod for S3 and S4 Mk3 and assume he speaks qml fluent therefore.