how to reinstall all libraries at once ?

aeronaut

The external disk with all my NI libraries on it has crashed and I need to reinstall them all.
However, in Native Access I can only install them one by one (and I have 323 of them). Is there an easy way to reinstall all the libraries all at once on the new SSD drive?
I just did the first two but this is going to take ages.

Maciej Repetowski

Don’t try to repair. Uninstall them all (takes few seconds per library), one by one. Then “install all”.

Maciej Repetowski

Don’t try to repair. Uninstall them all (takes few seconds per library), one by one. Then “install all”.

PoorFellow

https://community.native-instruments.com/discussion/31770/how-to-reinstall-all-libraries-at-once

Try deleting the products from your Mac that might make them available for install :

How to Uninstall Native Instruments Software from a Mac Computer

Maciej Repetowski

https://community.native-instruments.com/discussion/comment/158165#Comment_158165

In my case (also Mac), uninstalling the library instead of repairing it or deleting it - made it available for install again. Best to check official NI way first, I think 🤔

PoorFellow

https://community.native-instruments.com/discussion/comment/158166#Comment_158166

Yes , you are absolutely right , bad choice of word on my part , I meant uninstall on Mac as referred to by the help article supplied by me. But while 'solving problem' I were also 'channeling' the help content where you delete the stuff when you want to uninstall..

Quote : "In order to uninstall your NI application manually, remove the following files and folders from your system:"

Ref. : How to Uninstall Native Instruments Software from a Mac Computer

Maciej Repetowski

https://community.native-instruments.com/discussion/comment/158226#Comment_158226

Yes, that’s absolutely correct, cause not everything can be uninstalled via NA - then it has to be done manually, as per article you quoted. But Kontakt libraries can be uninstalled one by one and then reinstalled all together via “install all”.

aeronaut

Thank you for the comments. I am doing the "uninstall" now one by one and then "reinstall all" in batches. That seems the safest way for me.

Maciej Repetowski

https://community.native-instruments.com/discussion/comment/158238#Comment_158238

As Mando says: “This is the Way”. 😜