Combining effects and filters.

This may not be a new question. Why can't I combine effects and filters into one list? The system of separation into effects and filters is logical only in the sense of increasing the cost of controllers. In a practical sense, this is not logical. Especially if you consider that it is almost impossible to remap native maps without creating a mapping from scratch. I believe that combining effects and filters into a common list will be met with almost applause. Thank you for your attention!
Comments
-
I can’t quite picture what you’re describing. Controller controls the software, and the software has one set of controls for an effects unit, and one single knob control for a filter (plus the buttons to switch between them.
i can’t quite figure out where a list comes into it. Could you help me understand?
0 -
I'm interested in the option of controlling effects using buttons and knobs that are assigned to filters by default. I have not yet found such an option in Kontrol S3
0
Categories
- All Categories
- 18 Welcome
- 1.7K Hangout
- 67 NI News
- 895 Tech Talks
- 4.6K Native Access
- 17.8K Komplete
- 2.2K Komplete General
- 4.8K Komplete Kontrol
- 6.3K Kontakt
- 1.1K Reaktor
- 407 Battery 4
- 923 Guitar Rig & FX
- 467 Massive X & Synths
- 1.5K Other Software & Hardware
- 6.4K Maschine
- 8.2K Traktor
- 8.2K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators